The IPM5.020X.1S70 with a 4-wire-system and an additional calibration contact for the 80% alignment, was designed for sensor sizes which are based on strain gauges. This must not necessarily be used, as the device is suitable for any other strain gauge measuring. Therefor the device provides a regulated 10 V bridge supply. The 5-digit display shows the measurements, respectively the scaled value of the measured variable. Optionally available are 4 changeover relays for the monitoring of limit values, the interfaces RS232/RS485 for data transfer to/from the device and analog outputs 0-10 VDC, 4-20 mA or 0-20 mA for further evaluation.
Panel meter IPM5 melt pressure strain gauges 96 x 48 mm
| Housing | 96 x 48 mm |
| Display | 5-digit 14 mm digit height Colour: red |
| Range displayed | -9999…99999 |
| Operation | front panel keyboard protection class IP65 |
| Input | Strain gauge / Melt pressure: 1 mV/V, 2 mV/V, 3.3 mV/V frei bis 6 mV/V with 80% calibration Digital input: <2.4V OFF, >10V ON, max. 30 VDC |
| Analogue Output | 0-20 mA Burden ≤500Ohm 12Bit 4-20 mA Burden ≤500Ohm 12Bit 0-10 VDC Burden ≥100kOhm 12Bit |
| Switch point | 2 or 4 relays (change-over contacts) 250 V / 5 AAC, 30 V / 5 ADC |
| Interface | RS232 or RS485 galvanic isolated |
| Power supply | 100-240 VAC 50/60 Hz / DC +/- 10% 10-40 VDC / 18-30 VAC 50/60Hz |
| Sensor supply | Bridge supply 10 VDC / 20-50 mA / 200-500 Ohm |
| Software properties |
|
 Datasheet
|
|
User Manual
|
The IPM5.020X.1S70 with a 4-wire-system and an additional calibration contact for the 80% alignment, was designed for sensor sizes which are based on strain gauges. This must not necessarily be used, as the device is suitable for any other strain gauge measuring. Therefor the device provides a regulated 10 V bridge supply. The 5-digit display shows the measurements, respectively the scaled value of the measured variable. Optionally available are 4 changeover relays for the monitoring of limit values, the interfaces RS232/RS485 for data transfer to/from the device and analog outputs 0-10 VDC, 4-20 mA or 0-20 mA for further evaluation.
Technical advice: 03303 / 50 40 66
