IsoPAQ-611 1-channel Loop Powered Isolator for separation of 0(4)-20 mA Signals

  • Galvanic isolation across input and output
    Protection against erroneous measurements due to parasitic
    voltages or ground loops
  • No power supply required
    Saving costs since wiring is reduced and line influences are omitted
  • Extremely slim design
    Extremely slim casing of 6.2 mm combined with very low self heating allow tight mounting
  • Protective Separation acc. to EN 61140
    Protects service personnel and downstream devices against
    impermissibly high voltage
  • Maximum reliability
    No maintenance costs
Datasheet
User Manual
Add to your Quote List

The input loop-powered isolator IsoPAQ-611 provides galvanic separation for 0(4) … 20 mA standard signals, while transferring the measurement signal to the output with a high degree of accuracy.

The unit avoids interference voltage carry-over and effectively suppressing parasitic noise. The very low drop voltage of 2.3 V and the high level of accuracy work together to make the IsoPAQ-611 the first choice in system design.

Intelligent design and their consequential avoidance of highly integrated components result in extremely long service lives and reliability – without any falsification of the measurement signal.

The IsoPAQ-611 requires no additional power supply since the auxiliary power is obtained from the input signal without distorting it. This not only saves costs during installation, but also increases reliability.

 

Technical Specification

Input

  
Input signal 0(4)-20 mA
Start-up current < 200 mA
Voltage drop Approx.  2.3 V at 20 mA
Overload ≤ 50 mA, 30 V

Output
Output signal 0(4)-20 mA
Load 600 Ω
Response time T99 5 ms
Residual ripple < 10 mVrms

General Data
Transmission error < 0.1 % full scale
Load error < 0.05 % of measured value / 100 Ω load
Temperature coefficient < 100 ppm/K
Test voltage 3 kV AC, 50 Hz, 1 min. all circuits against one another
Working voltage (Basic insulation) 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1
Protection against electrical shock Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits.
Ambient temperature Operation
– 25 to + 70 °C (– 13 to + 158 °F)
Transport and Storage
– 40 to + 85 °C (– 40 to + 185 °F)
EMC EN 61326-1
Construction 62 x 96,5 x 107 mm , protection class IP 20, mounting on 35 mm DIN rail acc. to EN 60715
Weight Approx. 70 g

 

Diese Website benutzt Cookies. Wenn du die Website weiter nutzt, gehen wir von deinem Einverständnis aus.
More info Accept